SCO UNIX Introduction: ------------- This document describes the procedure to install the SCO UNIX driver for REALTEK RTL8019 Plug&Play ethernet adapter. Location of Driver: \SCO\5.X\DRIVER.O ------------------ The following files will be used in this installation: ------------------------------------------------------ driver.o : RTL8019 MDI Driver Program setup : Transfer dos format to unix format setup program master : Used by netconfig system : Used by netconfig node : Used by netconfig space.c : Used by netconfig space.h : Used by netconfig lkcfg : Used by netconfig AOF/r2e : Used by netconfig Installing driver procedure on SCO UNIX : ---------------------------------------- Before you start with the installation process, make sure that the SCO UNIX system is properly installed. Similarly,your adapter should also be properly installed in your machine. 1. Login as root user. (On maintenance mode) 2. Put RTL SCO UNIX Driver diskette to floppy A: and use doscp command to copy the file "setup" for installing RTL SCO UNIX PnP Driver into UNIX's directories as following : # cd / # doscp A:setup /setup !! if you don't have the directory ,namely, "a:/sco/4.x/." in the disk, you should modify contents of the setup file in the floppy. Please check contents of the setup file. # chmod +x /setup # ./setup 4. Use netconfig utility Avaiable options : # netconfig The screen will display the following messages, and Select item (1) to Add a chain : 1) Add a chain 2) Remove a chain 3) Reconfigure an element in a chain 4) Quit 5. After the above option completed, the screen display next option messages : Select item (4) : sco_tcp SCO TCP/IP for UNIX 6. When the user completed the above option, then various adapter drivers in SCO UNIX occur and select " RTL PnP Family Ethernet Driver board 0" item. 7. Add chain sco_tcp -> pnp0 (y/n), TYPE 'y' 8. Enter the internet Address of this interface , for example : 192.9.9.1 9. Enter the netmask for this interface (default 255.255.255.0). 10. Does the interface use a broadcast address of all 1's (y/n), default : y 11. Enter the boardcast address for this interface, default : xxx.xx.x.255 press ENTER 12. Are these values correct ? (y/n) TYPE 'y' 13. Pseudo ttys are currently configured, do you want to: 1) Add Pseudo ttys 2) Remove Pseudo ttys Select an option or enter q to quit [q] TYPE 'q' 14. Available options: 1) Add a chain 2) Remove a chain 3) Reconfigure a element in a chain q. Quit Select option: q 15. Do you want to relink to kernel now ? y 16. Do you want this kernel to boot by default (y/n) y 17. Do you want the kernel environment rebuilt (y/n) y 18. Reboot unix # shutdown -g0