PICNIC  and  HAWAII  Array  Controller  Box  Wiring

DB-37	Description	DB-25M 	Harness	Voltage Set to:
1	VD (ANALOG POWER)			015-3	+5.00 Volts
2	GND (GROUND PLANE)			09-6	Gnd
3	BUSS JFET 1			09-2	
4	BUSS JFET 2			09-4	
5	BUSS JFET 3			19-2	
6	BUSS JFET 4			19-4	
7	VRESET				015-2	+0.5 Volts
8	ICTL BIAS			015-4	+3.70 Volts
9	VDD (DIGITAL POWER)			015-5	+4.0 Volts
10	RESET CLOCK			37-1	+0 to +5 Volts
11	LINE CLOCK			37-2	+0 to +5 Volts
12	LSYNC CLOCK			37-3	+0 to +5 Volts
13	FSYNC CLOCK			37-4	+0 to +5 Volts
14	PIXEL CLOCK			37-5	+0 to +5 Volts
15	VOFFSET (PREAMP OFFSET)			015-1	+3.70 Volts
16	LIMIT SWITCH #1	19		
17	READ CLOCK			37-6	+0 to +5 Volts
18	LIMIT SWITCH #2	21		
19	LIMIT SWITCH RETURNS	22		
20	+15VDC (PREAMP PWR)			015-9	+15 Volts
21	-15VDC (PREAMP PWR)			015-10	-15 Volts
22	LAMP+ (ILLUMINATOR)	1		
23	LAMP- (ILLUMINATOR)	2		
24	DEWAR CASE	3****(See Grounding Scheme note below)
25	AUTOFILL OUTPUT	4		
26	MOTOR R1	5		
27	MOTOR W1	6		
28	MOTOR B1	7		
29	MOTOR Y1	8		
30	TRAVEL LIMIT	9		
31	HEATER (TO CASE)			
32	TEMP SENSOR +			
33	TEMP SENSOR -			
34	MOTOR Y2	13		
35	MOTOR B2	23		
36	MOTOR W2	24		
37	MOTOR R2	25		

Grounding Scheme:
	DB-37M pin 2 goes to 09-6, 09-7 then goes to 19-6.  19-7 then goes to 37-23.  DB-37M pin 24 has one wire to case and the other to DB25M pin 3.
Naming Scheme:
	09-# means the 9 pin connector on Video board #0, 015-# means the 15 pin connector on Video board #0  and  37-# means the Clock Driver 37 pin connector.